Hot water heater Care And Maintenance – Plumbing Repairs And Plumbing Information

Your water heater is one pretty used and higher priced appliances in your home, and consumes a large portion of your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and energy costs.

Regular flushing of your water heater are probably the single most important step you can take to prolong its service life this particular save energy. Over a period of time, sediments strengthen in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not merely destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most regions of the country, the average water heater lasts 3-5 years. Regularly flushing your hot water heater can double the life of your hot water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most out of your heater is critical in today’s economic condition. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs in half. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a nights.

To drain your water heater, you can find should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is an electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on a water inlet line going into your water heater. Equipped to connect a hose to the drain valve located towards the bottom of the hot water heater. Open the drain and allow it to move until all on the water has emptied from the heater. Then close the drain. Open the water supply valve and refill the heating. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until drinking water flows out smoothly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat in order to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so is actually always less corrosive to your plumbing system, particularly in areas possess hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and products to be fitting.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2