Duct Cleaning Offers a Simple, Affordable Solution for Making improvements to Indoor Air Quality

Your water heater is one pretty used and more expensive appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and energy costs.

Regular flushing of the water heater is among the single most important step you can take to prolong its service life additionally, you will save energy. Over a period of time, sediments build up in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most associated with the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your hot water heater from 3-5 to 7-10 years. Device costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is a must in today’s weather. In addition, regular flushing makes your water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of warm water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.

To drain your water heater, initially you should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is actually electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located on the water inlet line going into your water heater. You may then connect a garden hose to the drain valve located in the bottoom of the hot water heater. Open the drain and allow it to run until all of your water has emptied from the heater. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere at home and stand there and watch it run for several minutes until water flows out gradually. This will allow air to vent from the heater and the hot water lines. Finally, you can turn the thermostat back to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so may less corrosive to your plumbing system, particularly in areas possess hard hot water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and products to be fitting.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2